11/19/2020 0 Comments Reloading 7.62 X25 Tokarev
About 25 of them are bad more than enough that I have got to eliminate them.I guess the chamfer device for 308 comes our of thé FAL reloading container.Id prefer to distribute them than reduce them, so the brass would last longer.I have to find if I can bum a chronograph to notice how quick the sabots are heading to move.
![]() Its a nice chance that the variety of lots I use for the Tok make use of the exact same quantity of Unique that I got fixed the measure for on the final set of 45s. I went out in the hillsides nowadays to take a several of my clean reloads. The first photo can be a focus on with five sabot times through it. Oddly enough, the sabots hadnt discarded by this point, and the holes appear like SWCs proceeded to go through. ![]() The 110gr round nose produced a large splashy damage and damaged the steel, but didnt penetrate. The DS round went through, and á 45 ACP from my Hi-point splashed mainly because well. The 2nd picture is certainly a piece of 14 in . mild steel (A36 structural, hot rolled). None of the models proceeded to go through, but the manufacturer round arrived close. Conclusion- the DS models chamber fine, and are usually precise at shut range. The powder load can be a little too light, as the brass just ejects a few of ft away, and I acquired a few of rounds that didnt chamber the next round. When the floor dries a little bit Ill capture at twenty fivé and fifty backyard focuses on and observe if a) the sabots peel off, and b) if the bullets are usually still traveling straight.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |